11 March 2016 - Forum Rules
Started by BlackMod, January 24, 2023, 01:01:07 PM
QuoteApply Patch using the xdelta command line:xdelta.exe -d -s (old_file) (delta_file) (decoded_new_file)old_file should be a copy of Legend of Zelda Spirit Tracks USdelta_file is the patch (zelda_spirit_tracks_dpad.xdelta)decoded_new_file is the filename after patching
Quote from: BlackMod on January 24, 2023, 01:01:07 PMThe patch comes with "xdelta.exe" which I opened and typed in what I assumed was the command I was intended to use (including variations)
Quote from: mziab on January 24, 2023, 05:16:49 PMTry Delta Patcher.
Quote from: Jorpho on January 24, 2023, 10:36:18 PMPerhaps you should elaborate on what you are typing and where you are typing it.
Quote from: BlackMod on January 25, 2023, 03:45:23 AMPicture link.
Quote from: Jorpho on January 26, 2023, 12:58:58 AMIs that Windows 10? Hold down Shift on your keyboard and right-click the folder in the sidebar; then select "Open Powershell window here". Then type cmd (and press enter). Then enter the command. Don't use parentheses.
Quote from: BlackMod on January 25, 2023, 03:45:23 AMThank you very much! This worked, though I had to turn off checksum validation for it to work. Don't know if that matters at all.
Quote from: KingMike on January 25, 2023, 11:14:27 AMAn unmodified ROM is 128MB.
Quote from: mziab on January 26, 2023, 04:38:32 AMThat depends on the actual differences between the expected ROM and yours.
Quote from: mziab on January 26, 2023, 04:38:32 AMtype cmd into the address bar
Quote from: BlackMod on January 27, 2023, 07:06:17 AMI'm having trouble finding hashes to match these to, however...It turns out the ROM the hacker used was a bad dump.
Quote from: BlackMod on January 27, 2023, 07:06:17 AMThat's useful, but it opens command prompt, not PowerShell. Though it doesn't make a difference in this case.
Quote from: mziab on January 27, 2023, 07:22:53 AMJorpho's advice was a very roundabout way of launching that.
QuoteYou don't need that extra step of launching PowerShell to run the commands specified in the readme.
Quote from: Jorpho on January 27, 2023, 09:47:08 AMWhat's the alternative? If you don't run it from a command prompt, isn't the window going to close right away before any message can be seen?
Page created in 0.066 seconds with 19 queries.